Gauges and Gauging - Multiple Choice Questions and Answer

Gauges and Gauging - Multiple Choice Questions and Answer Points : gauges and gauging, mechanical engineering, metrology, mechanical technology, mcqs, evaluation, judgment, gauging, rating, consideration, analysis, examination, workup, test, review, objective type question and answer, multiple choice questions and answer Multiple Choice Questions and Answers 1. The diameter of very large bores can be measured accurately by:
(a) Keil part gauge
(b) Cylindrical gauge
(c) Swinging a pin gauge in the bore
(d) All of the above

2. A feeler gauge is used to check:
(a) Surface roughness
(b) Screw pitch
(c) Surface roughness
(d) Thickness of clearance

3. In wire gauge the slots has been numbered it is available from gauge 1 to 10.
(a) 20
(b) 30
(c) 40
(d) 50

4. A gauge is a tool to used to measure the readings of an object is called:
(a) Diameter Gauge
(b) Radius Gauge
(c) Feeler Gauge
(d) All of the above

5. The vernier height gauge may be used in metal to mark items for machining at the specific.
(a) Depth
(b) Diameter
(c) Height
(d) None of the above

6. The plate of holes of various sizes, which have been drilled by an are equal to different sizes bits:
(a) Pin Gauge
(b) Dove tail gauge
(c) Sheet metal gauge
(d) Drill gauge

7. For gauging parallel internal screw threads gauge recommended:
(a) Go and No go plug gauges to check the tolerance on the minor diameter
(b) A Go screw plug gauge to check the minimum effective diameter
(c) A No Go screw plug gauge to check the maximum effective diameter
(d) All of the above

8. The diameter of large bore cannot be easily measured by micrometer or vernier etc. can be measured by:
(a) Height Gauge
(b) Snap Gauge
(c) Pin Gauge
(d) All of the above

9. The moderation of neutrons by hydrogen atom is used as the basis for moisture detection in the instrument of:
(a) Profile Gauge
(b) Nuclear moisture gauge
(c) Dead weight gauge
(d) All of the above

10. The two slip gauges in precision measurement are joined by:
(a) Sliding
(b) Slipping
(c) Assembling
(d) None of the above

11. Which of the following is not accessory of slip gauges:
(a) Measuring jaws
(b) Holder
(c) Base
(d) Calipers

12. The following type of gauge has gauging sections combined on one end:
(a) Limit gauge
(b) Fixed gauge
(c) Progressive gauge
(d) Go and No Go gauges