Lathe Cutting Tools - Multiple Choice Questions

Lathe Cutting Tools - Multiple Choice Questions Points :Lathe Cutting Tools Multiple Choice Questions Answers, Mcqs Multiple Choice Questions 1. Knurling is done on Lathe.
(a) Yes
(b) No
(c) Yes/No
(d) All of these

2. Cutting tool is hold in ________.
(a) Head stroke
(b) Centre Rest
(c) Chuck
(d) Tool Post

3. The most common tool bit is the general all-purpose bit made of _______.
(a) High-speed steel
(b) Cast Iron
(c) Rubber
(d) All of these

4. Cutting Tool is ___________ in Lathe.
(a) Static
(b) Moved
(c) Not necessary
(d) These all correct

5. Rake angles cannot be too _______ or the cutting edge.
(a) Greater
(b) Smaller
(c) Larger
(d) Little

6. Single point tool bits can be _____ end of a high-speed steel tool bit.
(a) Wooden
(b) One
(c) Two
(d) Three

7. Tool post is ___________ the Carriage.
(a) Above
(b) Below
(c) Right side
(d) Left side

8. The overall shape of the lathe tool bits can be _______________.
(a) Rounded
(b) Square
(c) Any shape
(d) All of these

9. The parting tool bit is also known as the cutoff tool bit.
(a) Yes
(b) No
(c) Yes/No
(d) All of these

10. Threads are cut on Lathe.
(a) Yes
(b) No
(c) Yes/No
(d) All of these