Tolerance Limits and Allowances - Fill in the Blanks

Tolerance Limits and Allowances - Fill in the Blanks Points : tolerance limits and allowances, mechanical engineering, metrology, mechanical technology, mcqs, evaluation, judgment, gauging, rating, consideration, analysis, examination, workup, test, review, objective type question and answer, fill in the blanks Fill in the Blanks

1. To give the limits of an angular dimension and to maintain to accuracy the tolerance is generally Bilateral.
2. The difference between the maximum shaft size and minimum hole is known as Allowance.
3. Tolerance permissible variation is both plus & minus, it is referred to a Bilateral tolerance.
4. A single tolerance value is given preceded by the plus or minus symbol (±).
5. In an interference fit, it is the maximum interference and is Negative Allowance.
6. A unilateral tolerance is always all plus or minus, either the plus or the minus value must be Zero.
7. The term Allowance in limits and fits is usually referred to minimum clearance between shaft and hole.
8. When tolerance distribution is on only one side of basic size, it is referred to as Unilateral tolerance.
9. In a clearance fit, this is the minimum clearance and is Positive Allowance.
10. A Bilateral tolerance is one which allows the variation in both direction from a design size.
11. In the case of unilateral tolerances, the dimension is allowed to vary in One direction.