- Keep on turning the handle until the cylinder is formed. If the diameter is not correct set the back roll in close and roll the container again. Release the top roll to take away the cylinder.
- Put the back roll to form the cylinder. It should also be parallel to the top roll.
- Put in the sheet between the top and bottom rolls. As the rolls catch it, raise it slightly. This will start the forming. Then lower the sheet so the back roll will hold it.
- To form cone shapes, clutch onto one corner of the metal so that the other edge goes during faster.
- Lock the top roll-release handle. Set the lower roll to the width, of the metal. be certain that it is parallel to the top roll.
- Home
- Lathe Machine
- Milling Machine
- Shaper Machine
- Planer Machine
- Slotter Machine
- Hydraulic Machines
- Boilers
- Wood Working Machines
- Work Holding Devices
- Wood Working Tools
- Gauges
- Measuring Tools
- Drilling Machines
- Saws
- Grinder
- Internal Combustion Engine
- Steam Engine
- Welding
- Safety Precautions
- Power Plant
- Gas Turbine Power Plant
- Casting Process
- Water and Steam Turbines
- Metallurgy
- Foundary
- Electronics
- Electrical
- Broaching, Boring Machine
- Auto & Diesel
- Objective
- Technical Theory
Search This Blog
Slip Roll Forming Machine and It Used
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Dont paste link here..